Jan 9, 2022 · I am setting up a new machine Shapeoko 3 xxl During the initialize machine sequence, I get an error that the machine is not able to find the ...
Dec 27, 2016 · So I bought an XXL and have been using it quite a bit with vcarve pro and love it! The only problem I do have with it though is that I ...
Missing: انیپکو? q= 39313
Jul 13, 2016 · I have installed the limit switches. The Z-axis functions correctly, but the X,Y do not. I have changed the grbl command values that I have ...
Missing: انیپکو? q= 39313
People also ask
How do I adjust my limit switch?
How are limit switches activated?
What mode is a limit switch?
Aug 26, 2023 · when i tried to initialize machine it does not move it just makes a rattling sound and it doesn't move and i goes on for maybe ten seconds ...
Missing: انیپکو? q= https:// read/ 39313
Jun 23, 2019 · This morning I realized that my x-limit switch had broken the “tip” off and it would not all my XXL to home. I became creative and used a small ...
Missing: انیپکو? q= 39313
Jan 11, 2022 · I have check all the limit switches through carbide motion, and they all are reading the correct axis. So when I initialize the machine, It goes ...
Missing: انیپکو? q= https:// 39313
Jun 11, 2019 · im no professional but try unhooking the wires going to the motors and try moving the x axis to the homing spot and see if you see any ...
Jul 17, 2019 · First see if loosening the hardware and pulling it into a better alignment works. If not, check that you don't have the X and Y axis homing ...
Missing: انیپکو? q= read/ 39313
In order to show you the most relevant results, we have omitted some entries very similar to the 8 already displayed.
If you like, you can repeat the search with the omitted results included. |